Click here to visit Bubbletubing.com 
Aeration 
Deicing 
Floating Fountains 
Bioaugmentation 
Aquatic Tools 
Bubble Curtains 
The two-part sealant combines with clay particles in your pond's water and from the pond's bottom to create a water-resistant polymer that plugs leaks.
SOILFLOC® Sealant is the most efficient polymer-based pond sealant available for your earthen canal, irrigation ditch or pond. When applied correctly to a pond containing silt and clay (the product won't work on rocky bottoms or bedrock), the polymer finds the leaks in the bottom of your pond or earthen body of water, settles in and expands over the course of two weeks, effectively sealing your pond and eliminating unwanted drainage and offering seepage control.
Natural water flow in your pond helps the polymer to find leaks, whether they're in the floor, wall or through rock formations and seal them. SOILFLOC® is a custom blend of linear and cross-linked polymers to seal any type of soil, for nearly any sized project.
From backyard ponds of 5 000 square feet or more up to miles of irrigation canals, SOILFLOC® is the most cost-effective solution for your water loss problems.
- Cost-effective
- Long lasting
- No need to drain water
- Locates leaks and seals
- Non-toxic, biodegradable
- Environmentally friendly
- Will not harm livestock
SOILFLOC® Sealant is a two-part product cast out by hand or applied with a hand-held crank spreader/applicator that is designer for applying fine powders and granules.
If your ditch, pond or canal has water in it and is currently leaking, then now would be the best time to apply. The leak creates suction, drawing the polymers into the problem areas to seal the leaks. The product won't work on rocky bottoms or bedrock.
Storage and handling directions:
- Keep in cool, dry area
- Keep out of direct sunlight
- Keep out of the reach of children
- Avoid contact with eyes or skin
Preparation for application: Remove as much silt as possible as well as aquatic plants located near the suspected leak. Prevent livestock (cows, horses, etc.) from accessing the water for up to 72 hours after application. Soil Floc is safe for the aquatic life.
Mixing: For best results, it's important to properly mix the two bags (part A and part B) BEFORE application. Use a cement mixer if you have one, then mix the two parts well for 10 to 15 minutes, so that the product dispenses quickly and easily into your water body. Part A is applied first, followed immediately by Part B. The two parts can be mixed together 50/50 prior to application. Mixing the product in small batches is recommended for consistency and accurate dosing.
For ponds smaller than 1/2 acre begin 10' away from the shore, broadcasting no more than 5' in front of you towards the shore, along the entire shoreline until you're 5-10' away from the next shore. Back up 5' and begin to reverse your direction, broadcasting 5' towards the shore to cover the gap. Work methodically going back and forth from one shoreline to the next until you can take the watercraft out of the water without going through the applied product.
If you're treating a body of water greater than 1/2 acre, depending on the grade, you may start further away from the shore.
Do not apply in wind or rain. Wear suitable eye protection and dust mask. In case of contact with eyes, rinse immediately with plenty of water and if needed, seek medical advice. Do not inhale.
*Application rates and methods can be found on the SOILFLOC® Sealant application instruction sheet. Do not under apply.
Apply:
- 4 oz. per 11 sq. ft. applied as follows
- SF Sealant Part A l 2 oz. per 11 sq. ft.
- SF Sealant Part B l 2 oz. per 11 sq. ft.