Soilfloc® Pond Sealant

SOILFLOC® Sealant is a two-part product cast out by hand or applied with a hand-held crank spreader/applicator that is designer for applying fine powders and granules.

If your ditch, pond or canal has water in it and is currently leaking, then now would be the best time to apply. The leak creates suction, drawing the polymers into the problem areas to seal the leaks. The product won't work on rocky bottoms or bedrock.

Storage and handling directions:

·         Keep in cool, dry area

·         Keep out of direct sunlight

·         Keep out of the reach of children

·         Avoid contact with eyes or skin

Preparation (Before Application)

·        Remove as much pond silt as possible.

·        Remove aquatic plants near the suspected leak area.

·        Keep livestock (cows, horses, etc.) out of the water during application and for up to 72 hours after treatment.

·        Soilfloc® is safe for aquatic life.

·        Turn off the aerators and even remove the diffuser. They should remain off for approximately five (5) days to ensure optimal treatment effectiveness.

·        Make sure you have a boat with a flat bottom available for the application process.

Mixing Instructions

·        For best results, mix Part A and Part B thoroughly before application, under DRY conditions, Use a cement mixer if available.

·        Mix both parts together for 10 - 15 minutes so the product dispenses quickly and evenly.

·        Mix in small batches to ensure consistency and accurate dosing.

Application Method

Ponds Smaller than ½ Acre

·       Start 10 feet from the shoreline.

·       Broadcast no more than 5 feet toward the shore.

·       Work along the entire shoreline until you are 5 -10 feet from the opposite shore.

·       Back-up 5 feet and reverse direction.

·       Broadcast 5 feet toward the shore to fill the gap.

·       Continue this back-and-forth‑ pattern from shoreline to shoreline.

·       Stop once the watercraft can exit without passing through the applied product.

·       After application, the time required for the product to settle and for the water to become completely clear may vary depending on water body conditions. Some of the product may temporarily remain on the water surface. In general, the water becomes clear again within one to three days.

·       As a general rule, faster leaks tend to seal faster. Most leaks are stopped within 24-72 hrs. Slow leaks. May take longer to seal. Wait 15 days prior to re-applying.

Ponds Larger than ½ Acre

·       You may need to start further from the shoreline. There are many ways to apply the product in a larger pond, from fertilizer broadcasters to leaf blower attachments.

Safety Precautions

·      Do not apply in wind or rain

·      Wear:

o   Eye protection

o   Dust mask

·      Avoid inhalation.

·      If product gets in eyes:

o   Rinse immediately with plenty of water

o   Seek medical advice if irritation continues

Application Rates

·        1 large unit per 4,840 square feet or 450 m² surface

·        1 small unit per 2,421 square feet or 225 m² surface

·        Do not under‑apply.

Best Conditions for Success

·         A minimum of 20% clay and/or silt base is required for best results.

o   Will not work on bare rock.

o   This product is not suitable for liner ponds; it is designed for use in natural ponds only.

·         Ideal water depth is 4 feet or more.

o   Depth creates the pressure needed to seal cracks.

·         If the leak location is unknown:

o   Treat the entire pond surface.

o   Partial treatment may waste product if the leak is missed.